BUILD A FOG HEAD - Page 1
ADDITIONAL MATERIALS (needed per fog head)
14" x 18" - 1/4" lauan
plywood
hot melt glue and gun
extension cord
lamp base and colored "party" light bulb
construction adhesive
Gray spray primer
latex paint
100% clear silicone caulk
First determine if you plan to use the head for fog or just as a lighted wall sculpture. Begin by using a sharp steak knife to cut out the eye areas and mouth area if using with fog. Use a rasp file or sand paper to smooth out the inside cut eye areas and mouth area if using with fog. Use a rasp file or sand paper to smooth out the inside cut edges of the mouth.
Next lay the head onto the piece of lauan plywood. Trace the outline of the head with a black marker or pencil. Also trace the inside of the mouth onto the plywood. This will help determine the best place to cut the hole for the fog duct hose. Trace a 3" hole around the mouth lines marked on the plywood.
